Yamaha RS7000 Owner's Manual - Page 247

4. The Sample Jobs 1 SAMPLE (Source Sample Number Knob 1] [Settings] 001 ~ 128, C001 ~ C128 Specifies the source sample voice. 2 KEY (Source Key Number Knob 2] [Settings] C-2 ~ G8 Specifies the key number of the source sample. 2 KEY (Key Number Knob 2] [Settings] C-2 ~ G8 Specifies the key number of the sample to be normalized. NOTE This parameter is not available when the specified sample is a Pitched Voice. NOTE • This parameter is not available when the specified source sample is a Pitched Voice. • When the last remaining sample is moved from a Sample Kit Voice, the entire sample voice is deleted. 3 SAMPLE (Destination Sample Number Knob 3] [Settings] 001 ~ 128, C001 ~ C128 3 RATIO Knob 3] [Settings] 001 ~ 800% Specifies the post-normalization sample level. A setting of 100% maximizes the level so that the highest peak level in the sample is just below clipping (maximum digital signal level). Settings below 100% reduce the level of the sample accordingly. Settings higher than 100% will raise the sample level above the maximum, producing deliberate clipping. Specifies the destination sample voice. 4 TYPE (Destination Type Knob 4] Original Waveform 100% Lower than 100% Higher than 100% [Settings] PITCHED, KIT: C-2 ~ G8 Specifies the type of the destination sample voice. 5 Selects the sample key number when the destination sample is a Sample Kit Voice type. 4 AUDITION F2] Plays the specified sample. NOTE The PITCHED option is not available when a Plays the normalized sample if pressed after [F4] (DO!) is pressed to normalize the sample. Sample Kit Voice is stored in the destination sample voice number. 5 DO F4] Executes the job. The Sampling Mode 5 AUDITION F2] Plays the specified move source sample. 6 DO F4] Executes the job. 05 NORMALIZE 6 CREATE F3] Saves the processed sample to the target sample number, overwriting the original sample. If the original sample is a Pitched Sample it will be overwritten at this point. If the original sample is part of a Sample Kit Voice a key-number selection page will appear. Maximizes (normalizes) the overall level of the specified sample. 1 24 3 6 5 [F2] [Knob 1] [Knob 2] [Knob 3] [F3] [F4] 1 SAMPLE (Sample Number Knob 1] [Settings] 001 ~ 128, C001 ~ C128 Specifies the sample voice to be normalized. 7 8 [Knob 2] [F3] 7 CREATE TO (Destination Key Number Knob 2] [Settings] C-2 ~ G8 Specifies the key number to which the processed sample will be saved. RS7000 247