Yamaha RS7000 Owner's Manual - Page 99

8. Changing the Sound of Voices (Voice Edit) Specifies the LFO waveform. A total of 7 waveforms are provided. Press [F4] to go to the USER wave setup page. TRI (Triangular wave) I User Wave Page Variation Time [F1] 9 0 A B C [Knob 1] [Knob 2] [Knob 3] [Knob 4] [F4] [F2] 2 The Pattern Mode SAW UP (Rising sawtooth) Variation Time SAW DOWN (Falling sawtooth) Variation Time SQU (Square wave) Variation Time S/H (Sample & hold) ......... Random Variation Variation Time 9 SLOPE Knob 1] Absolute [Settings] OFF, UP, DOWN, UP&DOWN OFF The waveform steps are not connected by slopes. The wave will be similar to a rectangular or sample-&hold wave. UP Slopes will be used to connect only steps which increase in amplitude. This produces composite rising sawtooth type waveforms. DOWN Slopes will be used to connect only steps which decrease in amplitude. This produces composite falling sawtooth type waveforms. UP&DOWN .......Slopes connect all steps. The result is a composite triangular waveform. Determines whether or not the steps of a user waveform will be connected by slopes. 0 STEP/TOTAL Knob 2], [F2] → [Knob 2] [Settings] STEP 1 ~ TOTAL STEP Absolute TOTAL 2, 3, 4, 5, 6, 8, 12, 16 STEP selects the step in the user waveform for which the amplitude will be specified via the STEP VALUE parameter, below. TOTAL specifies the total number of steps per one cycle of the user waveform. More steps allow more complex waveforms. Press [F2] to move the cursor to the TOTAL parameter and set the total number of steps using [Knob 2]. RS7000 99