Yamaha RS7000 Owner's Manual - Page 277
Insert the AIEB2 I/O expansion board., Connect the flat cable from the I/O expansion board the thin
View all Yamaha RS7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 277 highlights
I/O cover 1. Installing Optional Equipment (B) 4. Plug in the flat cable backward. • Disconnect the flat cable. • Insert the opposite plug into the connector. The connector has a cut-out that prevents it from being connected in an incorrect orientation. 5. Connect the flat cable. • Connect the flat cable from the I/O expansion board (the thin, flat cable) to the corresponding connector on the RS7000's circuit board (marked "C" in the illustration below: CN16). The connector is "keyed" so that it will only go in one way. CN 16 C 6. Insert the AIEB2 I/O expansion board. • Support the I/O expansion board as shown in the illustration below, and fasten it to the rear panel by screwing in the three screws (B) that you removed at Step 3 above. (B) RS7000 277 Appendix