Yamaha RS7000 Owner's Manual - Page 278
Connect the other red/white cable 4-wire in the same way., Secure the cables to the bundle tie.
View all Yamaha RS7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 278 highlights
CN 4 CN 1 CN 2 CN 6 CN 7 CN 4 CN 1 CN 2 CN 6 CN 7 1. Installing Optional Equipment 7. Connect the 3-wire red/white cable. • Of the two red/white cables that extend from the I/O expansion board, first connect the 3-wire cable to the connector shown in the illustration below (CN7: 3-pin). Make sure that the direction is correct, and do not try to force the connection. 8. Connect the other red/white cable (4-wire) in the same way. • Connect the cable to the connector shown below (CN2: 4-pin). 9. Secure the cables to the bundle tie. • Run the 3-wire and 4-wire cables through the bundle tie (see illustration below), and secure them. Bundle tie 278 RS7000
1. Installing Optional Equipment
278
RS7000
7.
Connect the 3-wire red/white cable.
•
Of the two red/white cables that extend from the I/O expansion board, first connect the 3-wire cable to the connector shown in the
illustration below (CN7: 3-pin).
Make sure that the direction is correct, and do not try to force the connection.
8.
Connect the other red/white cable (4-wire) in the same way.
•
Connect the cable to the connector shown below (CN2: 4-pin).
9.
Secure the cables to the bundle tie.
•
Run the 3-wire and 4-wire cables through the bundle tie (see illustration below), and secure them.
CN 7
CN 6
CN 1
CN 4
CN 2
CN 7
CN 6
CN 1
CN 4
CN 2
Bundle tie