Cisco 1601 Hardware Installation Guide - Page 196

Access Point High-Speed WAN Interface Cards Access Point High-Speed WAN Interface Cards Warning During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94 Warning Do not operate your wireless network device near unshielded blasting caps or in an explosive environment unless the device has been modified to be especially qualified for such use. Statement 245B Warning In order to comply with FCC radio frequency (RF) exposure limits, antennas should be located at a minimum of 7.9 inches (20 cm) or more from the body of all persons. Statement 332 Warning Do not work on the system or connect or disconnect cables during periods of lightning activity. Statement 1001 Warning Read the installation instructions before connecting the system to the power source. Statement 1004 Warning Ultimate disposal of this product should be handled according to all national laws and regulations. Statement 1040 Access Point HWIC LEDs The access point HWIC LEDs are shown in Figure 132 and Figure 133. The functions of the LEDs are described in Table 39. Table 39 LED OK DATA Access Point HWIC LEDs Description Off if the access point HWIC is administratively shut down or there is no service set identifier (SSID) configured. Blinks if an SSID is configured but there is no client associated. On (solid green) if one or more clients are associated. Off if the access point HWIC is administratively shut down or there is no SSID configured. Blinks if there is activity (sending or receiving packets). OL-12854-01 4