D-Link DSR-150N DSR-150 User Manual - Page 255

Unified Services Router User Manual 0x%08x 0x%08x, 0x%08x 0x%08x 0x%08x 0x%08x, DEBUG sc_txq[%d] : , i DEBUG tid %p pause %d : , tid, tid->paused %d: %p , j, tid->tx_buf[j] DEBUG DEBUG %p , buf axq_q: %s: unable to reset hardware; hal status %u, __func__, status DEBUG DEBUG DEBUG ****ASSERTION HIT**** MacAddr=%s , DEBUG DEBUG TxBufIdx=%d, i DEBUG Tid=%d, tidno AthBuf=%p, tid->tx_buf[i] %s: unable to reset hardware; hal status %u, %s: unable to reset hardware; hal status %u, DEBUG DEBUG DEBUG DEBUG %s: unable to start recv logic, DEBUG _fmt, __VA_ARGS__ \ sample_pri=%d is a multiple of refpri=%d, sample_pri, refpri ===========ft>ft_numfilters=%u ft>ft_num filters filter[%d] filterID = %d rf_numpulses=%u; rf->rf_minpri=%u; rf>rf_maxpri=%u; rf->rf_threshold=%u; rf>rf_filterlen=%u; rf->rf_mindur=%u; rf>rf_maxdur=%u,j, rf->rf_pulseid, NOL WARNING!!! 10 minute CAC period as channel is a weather radar channel %s disable detects, __func__ %s enable detects, __func__ %s disable FFT val=0x%x , __func__, val %s enable FFT val=0x%x , __func__, val %s debug level now = 0x%x , __func__, dfs _debug_level RateTable:%d, maxvalidrate:%d, ratemax:%d, pRc->rateTableSize,k,pRc>rateMaxPhy %s: txRate value of 0x%x is bad., __FUNCTION__, txRate Valid Rate Table:- DEBUG DEBUG DEBUG DEBUG DEBUG DEBUG DEBUG DEBUG DEBUG DEBUG DEBUG DEBUG DEBUG DEBUG ath_pci: 32-bit DMA not available ath_pci: cannot reserve PCI memory region ath_pci: cannot remap PCI memory region) ; ath_pci: no memoryfor device state %s: unable to attach hardware: '%s' (HAL status %u), %s: HAL ABI mismatch; %s: failed to allocate descriptors: %d, %s: unable to setup a beacon xmit queue!, %s: unable to setup CAB xmit queue!, %s: unable to setup xmit queue for %s traffic!, %s: unable to register device, dev>nam e %s: autocreation of VAP failed: %d, ath_dev_probe: no memoryfor device s tate kdot11RogueAPEnable called with NULL argument. kdot11RogueAPEnable: can not add more interfaces kdot11RogueAPGetState called with NULL argument. kdot11RogueAPDisable called with NULL argument. %s: SKB does not exist., __FUNCTION__ %s: recvd invalid skb unable to register KIFDEV to UMI The system is going to factory defaults s, msg %02x, *(data + i) Inside crypt_open in driver ###### Inside crypt_release in driver ###### Inside crypt_init module in driver @@@@@@@@ Inside crypt_cleanup module in driver @@@@@@@@ SKB is null : %p ,skb DST is null : %p ,dst ERROR ERROR ERROR ERROR ERROR ERROR ERROR ERROR ERROR ERROR ERROR ERROR ERROR ERROR ERROR ERROR ERROR ERROR ERROR ERROR CRITICAL CRITICAL CRITICAL CRITICAL CRITICAL CRITICAL CRITICAL CRITICAL CRITICAL 253