Dell PowerEdge M520 Dell Converged Enhanced Ethernet Command Reference - Page 141

debug lacp 7 debug lacp Synopsis Operands Enables debugging for the Link Aggregation Control Protocol (LACP). debug lacp {all | cli | event | nsm | pdu {rx {all | interface {in | ex}tengigabitethernet slot/port} | tx {all | interface {in | ex}tengigabitethernet slot/port}}| sync | timer | trace level number} no debug lacp {all | cli | event | nsm | pdu {rx {all | interface {in | ex}tengigabitethernet slot/port} | tx {all | interface {in | ex}tengigabitethernet slot/port}}| sync | timer | trace level number} all Turns on all debugging. cli Turns on command line interface debugging. event Turns on event debugging. nsm Turns on Network Services Module (NSM) debugging. pdu Turns on PDU debugging. rx all Turns on debugging for received LACP packets on all interfaces. rx interface Turns on debugging for received LACP packets on the specified interface. interface tengigabitethernet Specifies the 10 Gbps Ethernet interface. slot Specifies the slot number. port Specifies the port number. tx all Turns on debugging for transmitted LACP packets on all interfaces. tx interface Turns on debugging for transmitted LACP packets on the specified interface. interface tengigabitethernet Specifies the 10 Gbps Ethernet interface. slot Specifies the slot number. port Specifies the port number. sync Turns on debugging for LACP sync transitions. timer Turns on debugging for LACP timers. trace level number Specifies the trace level number. The range of valid values is 1-7. Defaults By default, debugging is not turned on. Command Privileged EXEC mode Modes Description Use this command to enable debugging for Link Aggregation Control Protocol (LACP). Use the no debug command to disable debugging. Usage To display debug outputs on a specific cmsh session, use the terminal monitor command. Guidelines Dell Converged Enhanced Ethernet Command Reference 125 53-1002115-01