Dell PowerEdge M520 Dell Converged Enhanced Ethernet Command Reference - Page 67
Use this command to set the switching characteristics of the Layer 2 interface. Use
View all Dell PowerEdge M520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
switchport 3 switchport Puts the interface to Layer 2 mode and sets the switching characteristics of the Layer 2 interface to the defaults. Synopsis switchport no switchport Operands none Defaults By default, all Layer 2 interfaces are mapped to default VLAN 1 and the interface is set to access mode. Command Interface configuration mode Modes Description Use this command to set the switching characteristics of the Layer 2 interface. Use the no switchport command to take the switch out of the Layer 2 mode. Usage For changing the interface configuration mode to trunk or changing the default VLAN mapping, use Guidelines additional switchport commands. Examples To put an interface in Layer 2 mode: switch(conf-if-te-0/1)#switchport To remove an interface from Layer 2 mode: switch(conf-if-te-0/1)#no switchport See Also show vlan brief, show interface switchport, switchport mode, switchport access, switchport trunk Dell Converged Enhanced Ethernet Command Reference 51 53-1002115-01