Dell PowerEdge M520 Dell Converged Enhanced Ethernet Command Reference - Page 163

mac access-group 10 mac access-group Synopsis Operands Applies rules specified in a MAC ACL to traffic entering an interface. mac access-group name [in] no mac access-group name name in Specifies the name of the standard or extended MAC access list. Specifies to filter inbound packets only. Default There are no access lists applied to the interface. Command Interface configuration mode Modes Description Use this command to apply a MAC ACL to a Layer 2 or a VLAN interface. You create the MAC ACL by using the mac access-list global configuration command. Use the no mac access-group command to remove the MAC ACL from the interface. Usage Guidelines You can assign one MAC ACL (standard or extended) to an interface. When a packet is received on an interface with a MAC ACL applied, the switch checks the rules in the ACL. If any of the rules match, the switch permits or drops the packet, according to the rule. If the specified ACL does not exist, the switch permits all the packets. Example To apply a MAC ACL named macacl2 on an interface: switch(conf-if)#mac access-group macacl2 in To remove a MAC ACL named macacl2 from an interface: switch(conf-if)#no mac access-group macacl2 See Also mac access-list standard, mac access-list extended, show access-lists Dell Converged Enhanced Ethernet Command Reference 147 53-1002115-01