Dell PowerEdge M520 Dell Converged Enhanced Ethernet Command Reference - Page 82

4 show interface show interface Synopsis Operands show interface [port-channel number | {in | ex}tengigabitethernet slot/port | switchport | tracked ] port-channel number Specifies to display the port-channel number. The range of valid values is 1-63. extengigabitethernet Specifies a valid external 10 Gbps Ethernet interface. slot Specifies a valid slot number. port Specifies a valid port number. intengigabitethernet Specifies a valid internal 10 Gbps Ethernet interface. slot Specifies a valid slot number. port Specifies a valid port number. switchport Specifies to display information for Layer 2 interfaces tracked Displays the tracked status of the interface. Defaults There are no default configurations for this command. Command EXEC mode Modes Description Use this command to display the detailed interface configuration and capabilities of all interfaces or for a specific interface. Usage There are no usage guidelines for this command. Guidelines Examples To display detailed information for 10 Gbps Ethernet interface 0/1: switch#show interface intengigabitethernet 0/1 InTenGigabitEthernet 0/1 is admin down, line protocol is down (admin down) Hardware is Ethernet, address is 0005.1e76.1aa5 Current address is 0005.1e76.1aa5 Pluggable media present, Media type is sfp Wavelength is 850 nm Interface index (ifindex) is 67174401 MTU 2500 bytes LineSpeed: 10000 Mbit, Duplex: Full Flowcontrol rx: on, tx: on Last clearing of show interface counters: 00:02:18 Queueing strategy: fifo Receive Statistics: 0 packets, 0 bytes Unicasts: 0, Multicasts: 0, Broadcasts: 0 64-byte pkts: 0, Over 64-byte pkts: 0, Over 127-byte pkts: 0 Over 255-byte pkts: 0, Over 511-byte pkts: 0, Over 1023-byte pkts: 0 Over 1518-byte pkts(Jumbo): 0 Runts: 0, Jabbers: 0, CRC: 0, Overruns: 0 66 Dell Converged Enhanced Ethernet Command Reference 53-1002115-01