Dell PowerEdge M520 Dell Converged Enhanced Ethernet Command Reference - Page 63
VLAN Commands
View all Dell PowerEdge M520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
VLAN Commands Chapter 3 interface vlan Synopsis Operands Configures a VLAN interface. interface vlan vlan_id no interface vlan vlan_id vlan_id Specifies the VLAN interface to configure. The range of valid values is from 1 through 3583. Defaults VLAN 1 is predefined on the switch. Command Modes Description Global configuration mode Use this command to configure a VLAN interface. Use the no interface vlan vlan_id command to delete a VLAN interface. Usage Guidelines All of the ports on the switch are a part of the default VLAN 4095. Make sure your converged mode interface is not configured to classify untagged packets to the same VLAN as the incoming VLAN-tagged packets. By configuring a converged interface to classify untagged packets (by using classifiers or the default port vlan_id) to the same VLAN as VLAN-tagged packets coming into the interface, the FCoE hardware sends out untagged packets to the CNA. These packets may be dropped, disrupting communications. Examples To create a VLAN with ID 56: switch(config)#interface vlan 56 switch-cmsh(conf-if-vl-56)# See Also interface switchport, fcf forward, shutdown Dell Converged Enhanced Ethernet Command Reference 47 53-1002115-01