Dell PowerEdge M520 Dell Converged Enhanced Ethernet Command Reference - Page 166
permit standard ACLs, Synopsis, permit, count, no permit, Operands, Defaults, Command, Modes
View all Dell PowerEdge M520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 166 highlights
10 permit (standard ACLs) permit (standard ACLs) Synopsis Operands Configures a MAC address rule to permit traffic based on the source MAC address. permit {MAC_ACL | any} [count] no permit {MAC_ACL | any} MAC_ACL any count Specifies the source host MAC address for which to set permit conditions. Use the format HHHH.HHHH.HHHH. Specifies any source MAC address. Enables the counting of the packets matching the rule. Defaults By default, no MAC ACLs are configured. Command Feature Access Control List Configuration mode Modes Description Use this command to configure rules to match and to permit traffic based on the source MAC address. You can also enable counters for a specific rule. There are 255 ACL counters supported per port group. Use the no permit command to remove a rule from the MAC ACL. Usage There are no usage guidelines for this command. Guidelines Example To create a rule in a MAC standard ACL to permit traffic from the source MAC address 0022.3333.4444 and to enable the counting of packets: switch(conf-macl-std)#permit 0022.3333.4444 count To delete a rule from a MAC standard ACL: switch(conf-macl-std)#no permit 0022.3333.4444 See Also mac-access-list extended, no seq 150 Dell Converged Enhanced Ethernet Command Reference 53-1002115-01