Dell PowerEdge M520 Dell Converged Enhanced Ethernet Command Reference - Page 255
QoS Commands
View all Dell PowerEdge M520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 255 highlights
QoS Commands Chapter 16 cee Applies a CEE Provisioning map on an interface. Synopsis cee default no cee Operands default Only a single map name, called default, is allowed. Defaults There is no CEE Provisioning applied on an interface. Command Interface configuration mode Modes Description Use this command to apply the CEE map on an interface. Use the no cee command to remove the CEE Provisioning map. Usage The CEE map applied on an interface should exist on the switch. Guidelines Examples To apply the CEE map on an interface: switch(conf-if-te-0/1)#cee default Because the switch does not allow applying a CEE map that does not exist, the following error displays: switch(conf-if-te-0/1)#cee test % Error: Map does not exist See Also cee-map Dell Converged Enhanced Ethernet Command Reference 239 53-1002115-01