HP 170X HP Jetdirect Print Server 170X Installation and Configuration - Page 25
TCP/IP Configuration, Introduction - jetdirect default ip
UPC - 882780300699
View all HP 170X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
3 TCP/IP Configuration Introduction To operate properly on a TCP/IP network, the HP Jetdirect print server must be configured with valid TCP/IP network configuration parameters, such as an IP address. Depending on your printer and system, this can be done in the following ways: Note When shipped from the factory, the HP Jetdirect print server has no IP address. If the HP Jetdirect print server is not configured with a valid IP address within two minutes after power up, a factory default value of 192.0.0.192 will be automatically assigned. This address must be reconfigured with a valid address for use on your TCP/IP network. O By downloading the data from a network-based UNIXserver using BOOTP (Bootstrap Protocol) and TFTP (Trivial File Transfer Protocol) each time the print server is turned on. The factory-default state of the HP Jetdirect print server is to initially use BOOTP/TFTP. ENWW TCP/IP Configuration 3-25