HP 170X HP Jetdirect Print Server 170X Installation and Configuration - Page 46
Using the arp and ping Commands - firmware
UPC - 882780300699
View all HP 170X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Using the arp and ping Commands You can configure an HP Jetdirect print server with an IP address using an ARP (Address Resolution Protocol) command from a supported system. The protocol is not routable, that is, the workstation from which the configuration is made must be located on the same network segment as the HP Jetdirect print server. Using the arp and ping commands with HP Jetdirect print servers requires the following: O Windows or UNIX system configured for TCP/IP operation O HP Jetdirect firmware version F.08.56 or later O The LAN hardware (MAC) address of the HP Jetdirect print server (specified on an HP Jetdirect configuration page, or on a label attached to HP Jetdirect external print servers) Note On some systems, superuser rights may be required for the arp command. After an IP address is assigned via arp and ping commands, use other tools (such as Telnet, embedded web server, or HP Web Jetadmin software) to configure other IP parameters. 3-46 TCP/IP Configuration ENWW