HP 635n HP Jetdirect Print Server Administrator's Guide (Firmware V.36) - Page 115
Step 3: Specify Action, HP Jetdirect IPsec/Firewall Wizard
UPC - 882780301016
View all HP 635n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 115 highlights
Table 5-6 Manage Custom Services page (continued) Item Description (Internet Control Message Protocol for IPv4/IPv6 networks), and IGMPv2 (Internet Group Management Protocol version 2). ● For TCP or UDP, you must specify the local Printer/MFP ports and remote host ports for the service. ● For ICMPv4 or ICMPv6, you must specify an ICMP message type for the service. ICMP message types are based on standards and are well known. ● For IGMPv2, local/remote ports or ICMP message types are not configured; all IGMP messages types are assumed. Service Type Specify the service type: ● Printer/MFP Service (default): A local service on the HP Jetdirect print server or device. ● Remote Service: A service on a remote host. Service Port If the protocol selected was TCP or UDP, select the ports for this custom service to use on the local printer/MFP, and the remote hosts. The default selection is Any Port. Depending on the service, select Port Range or Specific Port, then enter the port range or port in the fields provided. ICMP Message Type If the protocol selected was ICMPv4 or ICMPv6, enter the ICMP message type number that will be used by the service. ICMP (Internet Control Message Protocol) does not use ports; instead, it uses well-known message types. NOTE: ICMP messages are typically used for error, control or information messages between network hosts. Add Configured Custom Services Delete Use this button to add the custom service to the Configured Custom Services list. This list identifies the custom services that have been configured. Use this button to delete a configured custom service from the list. Select the service to be deleted and click Delete. However, to delete a custom service, it cannot be specified for use by an active service template. Step 3: Specify Action For the addresses and services specified for this rule, select an action for the print server. Selectable actions on this page depend on whether IPsec is supported. ● Allow traffic. (If IPsec is supported, allow traffic to pass without IPsec protection.) ● Drop traffic. Do not process (discard) the specified IP traffic. ● Require traffic to be protected with an IPsec/Firewall policy. This option appears if IPsec/Firewall features are supported. If IPsec is supported, you will be prompted to select or configure an IPsec template to be applied to the specified IP traffic. ENWW HP Jetdirect IPsec/Firewall Wizard 105