HP 635n HP Jetdirect Print Server Administrator's Guide (Firmware V.36) - Page 57
TCP/IP LPD Queues, TCP/IP Raw Print Ports, TCP/IP Access Control
UPC - 882780301016
View all HP 635n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Table 3-3 Telnet Commands and Parameters (continued) interlock Specifies whether an acknowledgement (ACK) on all TCP packets is required before the printer is allowed to close a Port 9100 print connection. A Port Number and Option value are specified. For HP embedded print servers, the default Port Number is 1. Option value 0 (default) disables interlock, 1 enables. For example, "interlock 1 1" specifies port 1, interlock enabled. mult-tcp-conn (Restrict Multiple Ports) Enables or disables multiple TCP connections. Allows you to restrict the use of multiple ports. 0 (default): allows multiple connections. 1: disables multiple connections. buffer-packing Enables or disables buffer packing for TCP/IP packets. 1 (default): is normal, the data buffer is packed before sending to the printer. 0: disables buffer packing, data is sent to the printer as it is received. write-mode Controls the setting of the TCP PSH flag for device-to-client data transfers. 0 (default): disables this option, flag is not set. 1: "all-push" option. The push bit is set in all data packets. TCP/IP LPD Queues addq Adds a user-defined queue. The queue name (up to 32 display-able ASCII characters), prepend string name, append string name, and processing queue (typically, RAW) must be specified in the command line. Up to six user-defined queues may be added. CAUTION: Avoid the differentiation of queue names through the use of lowerand uppercase characters only. Otherwise, management of LPD queues by other tools may yield unpredictable results. deleteq defaultq addstring deletestring TCP/IP Raw Print Ports raw-port Delete a user-specified queue. The queue name must be specified in the deleteq command line. Name of the queue to be used if the queue specified for a print job is unknown. By default, the default queue is AUTO. Adds a user-defined character string that may be prepended or appended to print data. Up to eight character strings may be specified. A string name and the character string contents are specified in the addstring command line. Deletes a user-defined string. The string name is specified in the deletestring command line. Specifies additional ports for printing to TCP port 9100. Valid ports are 3000 to 9000, which are application-dependent. Up to two ports can be specified. TCP/IP Access Control allow Makes an entry into the host access list stored on the HP Jetdirect print server. Each entry specifies a host or network of hosts that are allowed to connect to the printer. The format is "allow netnum [mask]" where netnum is a network number or host IP address, and mask is an address mask of bits applied to the network number and host address to verify access. Up to 10 access list entries are allowed. If there are no entries, all hosts are permitted access. For example, allow 192.0.0.0 255.0.0.0 : allows hosts on network 192. ENWW IPv4 Configuration 47