HP 635n HP Jetdirect Print Server Administrator's Guide (Firmware V.36) - Page 63

EN_SNAP, EN_8022, EN_II, HP Jetdirect, Configuration s,

Get HP 635n - JetDirect IPv6/IPsec Print Server PDF manuals and user guides
UPC - 882780301016
View all HP 635n manuals
Add to My Manuals
Save this manual to your list of manuals

Page 63 highlights

Table 3-3 Telnet Commands and Parameters (continued) If the list is empty, the print server does not send SNMP traps. The list may contain up to six entries. The default SNMP Trap Destination List is empty. To receive SNMP traps, the systems listed on the SNMP trap destination list must have a trap daemon to listen to those traps. IPX/SPX ipx-config Enables or disables IPX/SPX protocol operation on the print server, if supported. 0 disables. 1 (default) enables. For example, ipx-config 0 will disable IPX/SPX operation. NOTE: HP Jetdirect 635n print servers: except for TCP/IP, network protocols are disabled by factory default. ipx-unitname Address ipx-frametype ipx-sapinterval ipx-mode ipx-nds-tree ipx-nds-context ipx-job-poll pjl-banner (ipx-banner) pjl-eoj (ipx-eoj) pjl-toner-low (ipx-toner-low) AppleTalk (Print Server Name) A user-assigned alphanumeric name assigned to the print server (31 characters maximum). By default, the name will be NPIxxxxxx, where xxxxxx are the last six digits of the LAN hardware address. (Read-only parameter) Identifies the IPX network and node numbers detected on the network, in the form :. Specifies the IPX frame type settings available for your print server model: AUTO (default), EN_SNAP, EN_8022, EN_8023, EN_II. For more information, see HP Jetdirect Configuration Pages on page 127. Specifies the time interval (1 to 3600 seconds) that the HP Jetdirect print server waits between Service Advertising Protocol (SAP) broadcasts on the network. The default is 60 seconds. 0 disables SAP broadcasts. (Read-only parameter) Specifies the NetWare mode configured on the print server, either RPRINTER or QSERVER mode. An alphanumeric string, up to 31 characters, that specifies the NDS tree name for the print server. An alphanumeric string, up to 256 characters, that specifies the NDS context for the HP Jetdirect print server. Specifies the time interval (1 to 255 seconds) that the HP Jetdirect print server will wait to check for print jobs in a print queue. The default is 2 seconds. Enables or disables printing an IPX banner page through Printer Job Language (PJL). 0 disables banner pages. 1 (default) enables banner pages. Enables or disables IPX end-of-job notification through PJL. 0 disables. 1 (default) enables. Enables or disables IPX toner-low notification through PJL. 0 disables. 1 (default) enables. ENWW IPv4 Configuration 53

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174
  • 175
  • 176
  • 177
  • 178
  • 179
  • 180
  • 181
  • 182
  • 183
  • 184
  • 185
  • 186
  • 187
  • 188
  • 189
  • 190
  • 191
  • 192
  • 193
  • 194
  • 195
  • 196
  • 197
  • 198
  • 199
  • 200
  • 201
  • 202
If the list is empty, the print server does not send SNMP traps. The list may contain up to
six entries. The default SNMP Trap Destination List is empty. To receive SNMP traps, the
systems listed on the SNMP trap destination list must have a trap daemon to listen to those
traps.
IPX/SPX
ipx-config
Enables or disables IPX/SPX protocol operation on the print server, if supported.
0
disables.
1
(default) enables.
For example,
ipx-config 0
will disable IPX/SPX operation.
NOTE:
HP Jetdirect 635n print servers: except for TCP/IP, network protocols
are disabled by factory default.
ipx-unitname
(Print Server Name) A user-assigned alphanumeric name assigned to the print server (31
characters maximum). By default, the name will be NPIxxxxxx, where xxxxxx are the last
six digits of the LAN hardware address.
Address
(Read-only parameter) Identifies the IPX network and node numbers detected on the
network, in the form <network number>:<LAN hardware address>.
ipx-frametype
Specifies the IPX frame type settings available for your print server model:
AUTO
(default),
EN_SNAP, EN_8022, EN_8023, EN_II
. For more information, see
HP Jetdirect
Configuration Pages
on page
127
.
ipx-sapinterval
Specifies the time interval (1 to 3600 seconds) that the HP Jetdirect print server waits
between Service Advertising Protocol (SAP) broadcasts on the network. The default is 60
seconds.
0
disables SAP broadcasts.
ipx-mode
(Read-only parameter) Specifies the NetWare mode configured on the print server, either
RPRINTER or QSERVER mode.
ipx-nds-tree
An alphanumeric string, up to 31 characters, that specifies the NDS tree name for the print
server.
ipx-nds-context
An alphanumeric string, up to 256 characters, that specifies the NDS context for the HP
Jetdirect print server.
ipx-job-poll
Specifies the time interval (1 to 255 seconds) that the HP Jetdirect print server will wait to
check for print jobs in a print queue. The default is 2 seconds.
pjl-banner
(ipx-banner)
Enables or disables printing an IPX banner page through Printer Job Language (PJL).
0
disables banner pages.
1
(default) enables banner pages.
pjl-eoj
(ipx-eoj)
Enables or disables IPX end-of-job notification through PJL.
0
disables.
1
(default) enables.
pjl-toner-low
(ipx-toner-low)
Enables or disables IPX toner-low notification through PJL.
0
disables.
1
(default) enables.
AppleTalk
Table 3-3
Telnet Commands and Parameters (continued)
ENWW
IPv4 Configuration
53