HP 635n HP Jetdirect Print Server Administrator's Guide (Firmware V.36) - Page 154

Table 8-13 Error Messages (continued) Error Code and Message Description 3F UNABLE TO GET NDS SRVR ADDR The NDS server address cannot be located or accessed. 40 ARP DUPLICATE IP ADDRESS The ARP layer has detected another node on the network using the same IP address as the HP Jetdirect print server. Extended error information below this message shows the hardware address of the other node. 41 NOVRAM ERROR The HP Jetdirect print server cannot read the contents of its NOVRAM. 42 INVALID IP ADDRESS The IP address specified for the HP Jetdirect print server (through BOOTP) is an invalid IP address for specifying a single node. Check your Bootptab file for proper entries. 43 INVALID SUBNET MASK The IP subnet mask specified for the HP Jetdirect print server (through BOOTP) is an invalid subnet mask. Check your Bootptab file for proper entries. 44 INVALID GATEWAY ADDRESS The default gateway IP address specified for the HP Jetdirect print server (through BOOTP) is an invalid IP address for specifying a single node. Check your Bootptab file for proper entries. 45 INVALID SYSLOG ADDRESS The syslog server IP address specified for the HP Jetdirect print server (through BOOTP) is an invalid IP address for specifying a single node. Check your Bootptab file for proper entries. 46 INVALID SERVER ADDRESS The TFTP server IP address specified for the HP Jetdirect print server (through BOOTP) is an invalid IP address for specifying a single node. Check your Bootptab file for proper entries. 47 INVALID TRAP DEST ADDRESS One of the SNMP trap (Trap PDU) destination IP addresses specified for the HP Jetdirect print server (through TFTP) is an invalid IP address for specifying a single node. Check your TFTP configuration file. 48 CF ERR - FILE INCOMPLETE The TFTP configuration file contained an incomplete last line that did not end in a newline character. 49 CF ERR - LINE TOO LONG A line being processed in the TFTP configuration file was longer than the HP Jetdirect print server could accept. 4A CF ERR - UNKNOWN KEYWORD A TFTP configuration file line contained an unknown keyword. 4B CF ERR - MISSING PARAMETER A line in the TFTP configuration file was missing a required parameter. 4C CF ERR - INVALID PARAMETER A line in the TFTP configuration file contained an invalid value for one of the parameters on that line. 4D CF ERR - ACCESS LIST EXCEEDED The TFTP configuration file specified too many access list entries using the "allow:" keyword. 4E CF ERR - TRAP LIST EXCEEDED The TFTP configuration file specified too many trap destination list entries using the "trap-destination:" keyword. 4F TFTP REMOTE ERROR The TFTP transfer of the configuration file from the host to the HP Jetdirect print server failed with the remote host sending a TFTP error packet to the print server. 50 TFTP LOCAL ERROR The TFTP transfer of the configuration file from the host to the HP Jetdirect print server failed with the local print server encountering some form of inactivity timeout, or excessive retransmissions situation. 51 TFTP RETRIES EXCEEDED The overall retrying of the TFTP transfer of the configuration file from the host to the HP Jetdirect print server has exceeded a retry limit. 52 BAD BOOTP/DHCP REPLY An error was detected in the BOOTP or DHCP reply that the HP Jetdirect print server received. The reply either had insufficient data in the UDP datagram to contain the minimum BOOTP/DHCP header of 236 bytes, had an operation field that was not 144 Chapter 8 HP Jetdirect Configuration Pages ENWW