HP 635n HP Jetdirect Print Server Administrator's Guide (Firmware V.36) - Page 151

Table 8-13 Error Messages (continued) Error Code and Message Description 13 NETWORK RECONFIG - MUST Reset or power off/on the HP Jetdirect print server to enable new configuration values. REBOOT 14 DISCONNECTED The Novell NetWare protocol is disconnected. Check the server and the print server. 15 CONFIGURATION ERROR (Ethernet) The configuration information for the NetWare functions is not stored correctly on the HP Jetdirect print server. Use the installation software, embedded Web server, or other tools to reconfigure the print server. If this error persists, there may be a problem with the HP Jetdirect print server. 16 NOT CONFIGURED (Ethernet) The HP Jetdirect print server has not been configured for NetWare. Use the installation software, embedded Web server, or other tools to configure the print server for NetWare networks. 17 UNABLE TO FIND SERVER (Ethernet) The HP Jetdirect print server was unable to find the NetWare print server (Remote Printer mode) or file server (Queue Server mode). (There was no response to service queries for advertising print servers or file servers that matched the configured print server or file server name.) Make sure that the print server or file server is running and that the print server or file server name configured on the HP Jetdirect print server matches the actual name used by the print server or file server. Also make sure that all cables and routers are functioning correctly. 18 PASSWORD ERROR The HP Jetdirect print server detected that the password for the NetWare print server object is wrong. Use a NetWare utility (such as PCONSOLE) to erase the password for the print server object. When the HP Jetdirect print server logs on again, it sets a new password. NOTE: When multiple file servers are configured, the error is only displayed on the configuration page if none of the file servers are connected. 19 NO QUEUE ASSIGNED The HP Jetdirect print server detected that the print server object has not been assigned any queues to service. Assign queues to the print server object using printer installation or NetWare utilities. NOTE: When multiple file servers are configured, the error is only displayed on the configuration page if none of the file servers were successfully connected. 1A PRINTER NUMBER NOT DEFINED A NetWare printer number for this printer has not been configured. Assign a valid printer number to the HP Jetdirect print server. Use a NetWare utility (such as PCONSOLE), the Jetdirect embedded Web server, or other tool to assign a printer number. 1B PRINTER NUMBER IN USE The NetWare printer number assigned to the printer is already in use by another printer. Assign an unused printer number. This may also occur when a print server is powered off/on, in which case the error goes away after the print server times out and detects the lost connection. 1C PRINT SERVER NOT DEFINED The file server does not have a print server object that corresponds to the specified NetWare node name. Use printer installation software, a NetWare utility (such as PCONSOLE), or other tool to create the print server object. When the HP Jetdirect print server is configured for multiple file servers, the error is only displayed on the configuration page if none of the file servers made the connection. 1D UNABLE TO CONNECT TO SERVER Remote Printer mode error. The HP Jetdirect print server was unable to establish an SPX connection with the NetWare print server. Make sure that the NetWare print server is running and that all cables and routers are functioning correctly. 1E FAIL RESERVING PRINTER NUM The SPX connection to the print server was lost when the HP Jetdirect print server attempted to reserve the printer number. This indicates a possible network problem, or ENWW HP Jetdirect Configuration Page 141