HP 8000dn Service Manual - Page 159
Power-On or Reset Sequence, PAPER FEED CYCLE, STAPLING CYCLE, EJECT CYCLE, STACKING
UPC - 088698569634
View all HP 8000dn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 159 highlights
PAPER FEED CYCLE STAPLING CYCLE EJECT CYCLE Figure 5-22 Stapler Cycles STACKING Power-On or Reset Sequence At power-on or reset, events are performed in the following sequence: 1 Stapler Assembly is set to a ready state. 2 Retainer Assembly is turned to its initial position. 3 Rack Assembly is moved to find its home position, which is in the left side of the Top Cover Assembly. 4 Slider Assembly is moved to find its home position, which is inside of the stapler bed. 5 Slider Assembly is moved fully out from the stapler bed to the eject position. 6 Rack Assembly is moved to activate the Exit Flap Assembly. 7 Slider Assembly is moved to its home position. 8 Rack Assembly is returned to its home position. EN Paper Paths and Components 135
EN
Paper Paths and Components
135
Figure 5-22
Stapler Cycles
Power-On or Reset Sequence
At power-on or reset, events are performed in the following sequence:
1
Stapler Assembly is set to a ready state.
2
Retainer Assembly is turned to its initial position.
3
Rack Assembly is moved to find its home position, which is in the
left side of the Top Cover Assembly.
4
Slider Assembly is moved to find its home position, which is
inside of the stapler bed.
5
Slider Assembly is moved fully out from the stapler bed to the
eject position.
6
Rack Assembly is moved to activate the Exit Flap Assembly.
7
Slider Assembly is moved to its home position.
8
Rack Assembly is returned to its home position.
PAPER FEED CYCLE
STAPLING CYCLE
EJECT CYCLE
STACKING