HP 8000dn Service Manual - Page 246
Tray 2 and 3 Assemblies, insert the tray no more than two inches into the chassis.
UPC - 088698569634
View all HP 8000dn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 246 highlights
Tray 2 and 3 Assemblies Note The paper trays are mechanically aligned to the printer chassis at the factory. If you are replacing Tray 2 or Tray 3 with a tray other than the original factory installed unit, you may have to adjust the new tray. For details, see "Tray Adjustment Procedure" on page 92. 1 Open the tray, and pull it out to the stop. 2 Carefully lift up on the outer end to release the tray stop mechanism at the right rear while continuing to pull the tray free of the chassis. To Reinstall: 1 Align the left rear corner of the tray and the locating track at the lower rear center of the tray with their respective guides, and insert the tray no more than two inches into the chassis. 2 Carefully lift up on the outer end of the tray while pulling the tray stop mechanism, located at the right rear of the tray opening, out and over the tray roller and guide assembly. 3 Carefully slide the tray into the printer until it latches into place. 222 Chapter 6 Removal and Replacement EN