HP 8000dn Service Manual - Page 411

Table 7-6. Numerical Printer Messages (continued) Message Event Description Log Category/ Message Recommended Action Error alternates with The printer encountered an error 1. Verify the cable while transferring data from the connections. Make sure that computer. The error might have the printer's serial occurred for several reasons: configuration is set the • The computer was powered on same as the computer from or off while the printer was the I/O Menu in the printer's online. control panel. • The printer's serial 2. The serial baud rate configuration was not the same setting can be accessed as the computer's. from the I/O Menu in the printer's control panel. 3. Press GO to clear the error message and continue the printing. 4. Turn the printer off. 5. Reseat the EIO card, and turn the printer on. Error alternates with The connection has been broken 1. Turn the printer off, and between the printer and the EIO reseat the card. card in the specified slot. 2. Press GO to clear the error message and continue printing. Error The paper size you are trying to print is not the same as the control panel setting for Tray 1. 1. Make sure that the control panel setting for Tray 1 or the Envelope Feeder is correctly adjusted for size. (The printer will continue trying to print the job until the size settings are correct.) 2. Press GO. The page containing the error will automatically be reprinted. (Or, you might want to press CANCEL JOB to clear the job from the printer's memory.) EN Printer Messages 387