HP 8000dn Service Manual - Page 410

Table 7-6. Numerical Printer Messages (continued) Message Event Description Log Category/ Message Recommended Action Error alternates with Too much data was sent to the 1. Press GO to clear the EIO card in the specified slot ( ). message. (Data will be lost.) An improper communications 2. Check the host protocol may be in use. configuration. Error alternates with Error alternates with Too much data was sent to the 1. Check for a loose cable parallel port. connection and be sure to This error can occur if the driver use a high-quality cable. you are using is not IEEE-1284 (Some non-HP parallel compliant. For best results, use cables might be missing pin an HP driver that came with the connections or might printer. otherwise not conform to the IEEE-1284 specification.) This error can occur if the driver you are using is not IEEE-1284 compliant. For best results, use an HP driver that came with the printer. 2. Press GO to clear the error message. (Data will be lost.) Too much data was sent to the serial port. 1. Make sure that the correct serial pacing option is selected from the I/O Menu in the printer's control panel. 2. Print a Menu Map, and verify that the serial pacing item (from the I/O Menu in the printer's control panel) matches the setting on the computer. 3. Press GO to clear the error message. (Data will be lost.) 386 Chapter 7 Troubleshooting EN