HP 8000dn Service Manual - Page 170
Required Tools, Phillips vs. Posidriv Screwdrivers
UPC - 088698569634
View all HP 8000dn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 170 highlights
Required Tools #2 magnetized Phillips screwdriver (6-inch shaft) Small flat-blade screwdriver Small pair needle-nose pliers T-15 Torx driver (6-inch shaft) All components in the printer, the 2000-sheet Input Tray, and the 2 x 500-sheet Input Tray use Phillips head screws that require a #2 size Phillips screwdriver. Figure 6-1 shows the difference between a Phillips and a Posidriv screwdriver. Note that the Phillips tip has more beveled surfaces. All screws used in the field-replaceable Multibin Mailbox/5-bin Mailbox with Stapler and 7-bin Tabletop Mailbox components require a T-15 Torx driver. Figure 6-1 Phillips vs. Posidriv Screwdrivers Note CAUTION See table 6-1 on page 157 and Chapter 8 for a list of the screws and other common hardware used in the printer. To install a self-tapping screw, first turn it counter-clockwise to align it with the existing thread pattern, then carefully turn clockwise to tighten. Do not over-tighten. If a self-tapping screw-hold becomes stripped, repair of the screw-hole or replacement of the affected assembly is required. 146 Chapter 6 Removal and Replacement EN