HP 8000dn Service Manual - Page 171
User Installable Accessories, Memory and Personality, Upgrade
UPC - 088698569634
View all HP 8000dn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 171 highlights
User Installable Accessories Memory and Personality Upgrade CAUTION DIMMs and the Formatter PCA can be damaged by small amounts of electrostatic discharge (ESD). Wear an anti-static wrist wrap. Print a configuration page (page 342). 1 Turn the printer off. Unplug the power cord, and disconnect any cables. Loosen the two captive thumb screws on the back of the printer. Grasp the screws and pull the formatter board out of the printer. Place it on a flat, non-conductive surface. 2 Remove the DIMM from the antistatic package. Hold the DIMM with fingers against the side edges and thumbs against the back edge. Align the notches on the DIMM with the DIMM slot. (Check that the locks on each side of the DIMM slot are open, or outward.) 3 Press the DIMM straight into the slot (press firmly). 4 Make sure the locks on each side of the DIMM snap inward into place. (To remove a DIMM, the locks must be released.) Slide the formatter board back into the printer, and tighten the two screws. Plug in the power cord and connect all cables. Turn the printer on. EN User Installable Accessories 147