HP 8000dn Service Manual - Page 395
MB RAM disk., print job. You can print
UPC - 088698569634
View all HP 8000dn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 395 highlights
Table 7-5. Alphabetical Printer Messages (continued) Message Event Description Log Category/ Message Recommended Action Warning The specified tray is open. Close the tray to continue. Error Tray does not contain the specified size of paper. Load the requested paper into the indicated tray, or press SELECT to override the message and to print on a loaded paper size. Error Memory or file system failures 1. Check to see if mopying is would not allow a mopy job to turned on. Turn mopying on occur. Either the printer is not through the available control configured to mopy or there is panel steps. inadequate printer RAM (disk) 2. Configure a minimum of memory. Inadequate available 8 MB RAM disk. RAM disk is a result of 3. Make sure that there is insufficient memory configured adequate available printer (8 MB) or the print job exceeded DIMM memory or hard disk the available configured space. The available space memory, including the on-board should exceed the size of the disk. Only one copy will be print job. (You can print the produced. job to a file on your PC and compare that with the available printer memory or hard disk space available.) Error An external paper handling Load a supported paper size device detected an unsupported in the tray. paper size. The printer will go offline until the condition is corrected. Error If the requested paper size or type is not available, the printer asks if it should use another paper size or type instead. 1. Press - VALUE + to scroll through the available types and sizes. 2. Press SELECT to accept the alternate type or size. EN Printer Messages 371