HP LaserJet 4v/mv Service Manual - Page 108
Rear and Top Area Assemblies
View all HP LaserJet 4v/mv manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 108 highlights
NOTE Figure 6-10 6cardcg 6cardcgwmf Rear and Top Area Assemblies Card Cage The Card Cage is located directly underneath the Upper Cover. It is not necessary to remove the Formatter or MIO from the Card Cage. 1 Disconnect the interface cable (Figure 6-10, callout 1). 2 Release the cable from the (3) cable clips (Figure 6-10, callout 2). Do not remove (2) screws indicated in Figure 6-20 by the null symbol ( ). 3 Remove (6) screws (four are in line with the cable clip, and two at the rear) from the top of the plate (Figure 6-10, callout 3). 4 Remove (1) screw from the back of the plate (Figure 6-10, callout 4). 5 Loosen (do not remove) (1) screw as shown in Figure 6-10, callout 5. 6 Lift the Card Cage off of the printer. Card Cage To Reinstall: When reinstalling the Card Cage pay careful attention to the routing of the cables and the position of the cable clip shown in Figure 6-10, callout 2. 6-16 Removal and Replacement