HP LaserJet 4v/mv Service Manual - Page 119
The Fuser Inlet Guide is located inside the Front Door assembly
View all HP LaserJet 4v/mv manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 119 highlights
Removal & 6 Replacement WARNING NOTE Figure 6-21 6inguide 6inguidewmf Fuser Inlet Guide The Fuser Inlet Guide contains the anti-static teeth. They are VERY sharp. The Fuser Inlet Guide is located inside the Front Door assembly just forward of the Transfer Roller. Do not remove (2) screws indicated in (Figure 6-21) by the null symbol ( ). 1 Remove the Transfer Roller (See Figure 6-19). 2 Remove (3) screws (washers on two end screws only) (Figure 6-21, callout 1). 3 Lift the rear edge of the guide to clear locating pins (Figure 6-21, callout 2). Push to the front while tilting the front edge upward to clear retaining tabs. CAUTION Fuser Inlet Guide To Reinstall: 1 To determine initial placement, align the guide over the locating pins but do not snap them into place. 2 While tilting the front edge downward to engage the retaining tabs, push the guide to the rear and downward to snap over the locating pins. The (2) washers must be in place (one on each outer screw) and the guide seated, with retaining tabs located correctly, or paper jams will occur. 3 Replace the (3) screws, ensuring that the (2) spring washers are in place. Removal and Replacement 6-27