HP LaserJet 4v/mv Service Manual - Page 44
Job Menu
View all HP LaserJet 4v/mv manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Table 3-7 Item RESOLUTION PERSONALTY PWRSAVE IO TIMEOUT PAGEPROTCT *Factory default. Job Menu The items available in the Job Menu can also be changed through software applications if an appropriate printer driver is installed. Job Menu Items Options 300 or 600* Explanation For most purposes, 600 dpi is recommended. AUTO* PCL PS Personality means printer language. The printer can switch from its standard personality, PCL, to other personalities, such as PostScript. When PERSONALTY is set to AUTO, the printer analyzes each print job it receives and switches personalities automatically. When you make another personality the default, the printer stops switching personalities automatically unless a software command specifically instructs it to do so. If the PostScript option is not installed, PERSONALTY will not display in the Job Menu. OFF, 15 MIN, 30 MIN*, 1 HR, 2 HRS, 3 HRS If you select PS as the default, you may want to set ADV FNCTNS in the Parallel Menu to OFF. Sets the amount of time the printer is idle before the fuser shuts down. The printer automatically starts warming the fuser when you send a print job to the printer, press a control panel key, load or remove paper, or open the top door. NOTE: A ten second interval is also available in Service Mode (see "Service Mode" later in this chapter). 5 to 300 15* AUTO* ON I/O timeout refers to the time, measured in seconds, that the printer waits before ending an incomplete print job (it scrolls in increments of 10). This setting allows you to adjust timeout for best performance. If data from other ports appears in the middle of the print job, increase the timeout value. You will not see this item unless the error 21 PRINT OVERRUN has occurred. (See Chapter 7 for error message troubleshooting.) 3-10 Operating Overview