HP LaserJet 4v/mv Service Manual - Page 151

7 Troubleshooting Clearable Warnings A clearable warning message indicates that the printer changed settings in order to complete the print job. A clearable warning usually occurs when a transient condition, such as an invalid or uninstalled personality, or lack of memory causes a temporary change. A number of clearable warnings can appear while printing a job. The printer will remain on line while the message is displayed. Clear the message by pressing [Shift] + [Continue]. It is possible to eliminate the need to respond to clearable warning messages (see "Configuration Menu" in Chapter 3). Table 7-3 Clearable Warning Messages Message Meaning W0 JOB 600/A4 Because the job parameters of print resolution and page protection could not be met with the available memory, the job was printed at a print resolution of 600 dpi but reduced to a page protect setting of A4. W1 IMAGE ADAPT The printer received a graphics print file that was too complex to print at the requested print resolution. Check the printout for loss of data or print quality. NOTE: if this warning occurs frequently, install additional memory. W2 INVALID PERS The job was not printed because you requested a personality, such as PostScript, that is not installed. Install the personality that matches the personality of the files you are sending, together with enough memory to support that personality. W3 JOB ABORTED The printer was forced to abort the print job because there is not enough installed memory to support the current printer language (PostScript, for example). Install additional memory. WD DISK NOT INIT The printer was unable to read the root directory from the disk. Use the disk initialization utility to initialize the disk. W8 JOB 600/OFF Because the job parameters of print resolution and page protection could not be met with the available memory, the job was printed at a print resolution of 600 dpi and page protect was turned OFF. W9 JOB 600/LTR Because the job parameters of print resolution and page protection could not be met with the available memory, the job was printed at a print resolution of 600 dpi but reduced to a page protect setting of LETTER. WM JOB 300 The job was printed at 300 dpi. NOTE: if this warning occurs frequently, install additional memory. WM JOB 600/A3 Because the job parameters of print resolution and page protection could not be met with the available memory, the job was printed at a print resolution of 600 dpi but reduced to a page protect setting of A3. WM JOB 600/LGL Because the job parameters of print resolution and page protection could not be met with the available memory, the job was printed at a print resolution of 600 dpi but reduced to a page protect setting of LEGAL. WM MEM CNFIG N/A The printer did not have enough memory when switched ON to support the previous settings for I/O Buffering and/or Resource Saving, probably because you removed a memory SIMM, or added a new personality SIMM. (You can check settings by printing a self test.) WM CHK MEM CNFIG I/O Buffering and/or Resource Saving settings were altered when the printer was switched on because the printer did not have enough memory. This usually occurs after memory has been removed from the printer. (You can check settings by printing a self test.) Adding additional memory should correct this problem. Troubleshooting 7-15