HP LaserJet 4v/mv Service Manual - Page 230
Configuring Novell NetWare Frame Type Parameters.
View all HP LaserJet 4v/mv manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 230 highlights
Table B-1 Configuring Novell NetWare Frame Type Parameters. Normally selecting a NetWare frame type is not required. The HP JetDirect card automatically selects a NetWare frame type, and only when this selection is incorrect do you have to set the NetWare frame type through the HP LaserJet 4MV control panel. The NetWare frame type is displayed on the self test page. To manually configure Novell NetWare parameters: 1 Press [Item] until CFG NOVELL=NO * appears. 2 Press [+] until CFG NOVELL=YES * appears. 3 Press [Enter]. CFG NOVELL=YES * appears. 4 Press [Item]. FRAME=AUTO * appears. 5 To configure the Novell NetWare protocol, Press [+] to select one of these frame types: Novell NetWare Frame Types on an HP JetDirect Ethernet Card Frame Type AUTO (default) EN_8023 EN_II EN_8022 EN_SNAP Description All listed Novell frame types will be allowed. Limit frame types to IPX over IEEE 802.3 frames. All others will be counted and discarded. Limit frame types to IPX over Ethernet II frames. All others will be counted and discarded. Limit frame types to IPX over IEEE 802.2 frames. All others will be counted and discarded. Limit frame types to IPX over SNAP with Ethernet frames. All others will be counted and discarded. 6 Press [Enter] to save the selection. An asterisk * appears. 7 If other protocols will be used, continue with the next section. Otherwise, skip to "Disable Network Protocols" at the end of this appendix. B-6 I/O Information