HP LaserJet 4v/mv Service Manual - Page 232
Configuring Apple EtherTalk Phase Parameter
View all HP LaserJet 4v/mv manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 232 highlights
Configuring Apple EtherTalk Phase Parameter To configure EtherTalk parameters: 1 If you do not want to configure the phase parameter, Press [On Line]. 2 Press [Item]. CFG ETALK=NO * appears. 3 Press [+]. CFG ETALK=YES appears. 4 Press [Enter]. CFG ETALK=YES * appears. 5 Press [Item]. Phase=2 * appears. 6 Press [+] to change the phase parameter. Phase=1 appears. 7 Press [Enter] to save the new value. Phase=1 * appears. 8 Press [On Line]. You may want to configure the AppleTalk name and assign a preferred EtherTalk Zone. 9 After completing this guide refer to the HP JetDirect Interface Configuration Guide for further configuration instructions on using the HP LaserJet Utility. B-8 I/O Information
Configuring Apple EtherTalk Phase Parameter
To configure EtherTalk parameters:
1
If you do not want to configure the phase parameter, Press
[On°Line]
.
2
Press
[Item]
.
CFG ETALK=NO *
appears.
3
Press
[+]
.
CFG ETALK=YES
appears.
4
Press
[Enter]
.
CFG ETALK=YES *
appears.
5
Press
[Item]
.
Phase=2 *
appears.
6
Press
[+]
to change the phase parameter.
Phase=1
appears.
7
Press
[Enter]
to save the new value.
Phase=1 *
appears.
8
Press
[On°Line]
. You may want to configure the AppleTalk name and assign
a preferred EtherTalk Zone.
9
After completing this guide refer to the HP JetDirect Interface
Configuration Guide for further configuration instructions on using the HP
LaserJet Utility.
B-8 I/O Information