HP M5025 Service Manual - Page 104

Table 3-18 Print/stop test time values (simplex print jobs) (continued) Time value1 First page stop Second page stop Third page stop 1,000 ms leading edge about 7 mm (0.27 inch) past fuser nip, 135 mm (5.31 inches) of page past the transfer roller Leading edge about 65 mm NA (2.55 inches) away from the registration roller, trailing edge of the page about 38 mm (1.49 inches) away from leaving the HCI (start the job from Tray 5) 2,000 ms Leading edge about 170 mm Leading edge about 18 mm (0.70 Trailing edge just leaving the HCI (6.69 inches) past the fuser nip inch) past the transfer roller (start the job from Tray 5) 3,000 ms leading edge about 154 mm (6.06 inches) past the standard face down exit rollers, trailing edge almost past the stapler diverter Leading edge about 75 mm (2.95 inches) past the fuser nip, Trailing edge about 10 mm (0.39 inch) from the transfer roller leading edge at the transfer roller 1 Use these values for a simplex print stop test. See Table 3-17 Troubleshooting menu on page 67. Table 3-19 Print/stop test time values (duplex print jobs) Time value1 0 ms First page stop Leading edge at TOP sensor (SR5) Second page stop NA Third page stop NA NOTE Opening the print-cartridge door pulls the sheet backward. 1 ms 2,000 ms 3,000 ms 5,000 ms 8,000 ms 10,000 ms 12,000 ms Leading edge about 20 mm NA NA (0.78 inch) past the TOP sensor (SR5) Leading edge about 170 mm (6.69 inches) past the fuser nip, but not out far enough to move back toward the duplexer Trailing edge just leaving the HCI NA (start the job from Tray 5) Leading edge entering the duplexer, trailing edge about 60 mm (2.36 inches) past the standard face down exit rollers (just past the reverse point) Leading edge about 30 mm (1.18 NA inches) past the top of the middle right door Leading edge about 25 mm (0.98 inch) out of the duplexer with second side already printed ready to re-feed Leading edge just prior to entering the fuser nip, trailing edge about 35 mm (1.37 inches) from the transfer roller (half the page contains toner) Leading edge about 175 mm (6.88 inches) past the HCI (Tray 5) pick rollers, trailing edge still at the ( HCI (Tray 5) pick rollers (start the job from Tray 5) Leading edge about 80 mm (3.14 inches) past the registration roller, second side already printed and fed from the duplexer Leading edge about 60 mm (2.36 inches) into the duplexer, second side already printed and reversed Leading edge about 175 mm (6.88 inches) past the HCI (Tray 5) pick rollers, trailing edge still at the ( HCI (Tray 5) pick rollers (start the job from Tray 5) Both sides fused, trailing edge leaving the fuser area to delivery First side fused, leading edge in the duplexer, and the trailing edge about 85 mm (3.34 inches) from the duplexer leading edge about 55 mm (2.16 inches) past the transfer roller (for first past print) Stops in stapler, then auto ejects First pass fused (other blank), Leading edge entering the leading edge in duplexer, and the duplexer, trailing edge about 74 Chapter 3 Manage and maintain the device ENWW