HP M5025 Service Manual - Page 462
Check The Glass And Remove Any Paper, Digital Send Server is not Responding - mfp printer driver
UPC - 882780575493
View all HP M5025 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 462 highlights
Table 6-2 Control-panel messages (continued) Control panel message Description Recommended action Bad duplexer connection The duplex printing accessory is not connected correctly to the device. 1. Remove and reinstall the duplexer. 2. If this message persists, the connector between the duplexer and the dc controller (J311) might be damaged. Inspect the connector on the duplexer . If the connector is damaged, replace the duplexer. Turn the power off and then on after replacing the duplexer. 3. If the message still persists, replace the dc controller. See DC controller PCA on page 357 Binname full The specified bin is full. Remove the media from the bin. Check The Glass And Remove Any Paper Source documents are loaded in the ADF, but Remove any media from the scanner glass To Continue Press Start there might be media on the scanner glass. and press Start to print the job. Checking engine The device is checking the engine. No action necessary. Checking paper path The device is activating internal rollers to check for jams. No action necessary. Chosen personality not available To continue touch OK A print job requested a language (personality) that is not available for this device. The job will not print and will be cleared from memory. Print the job by using a printer driver for a different printer language, or add the requested language to the device (if possible). To see a list of available personalities, print a configuration page. Cleaning . . . The device is processing a cleaning page. No action necessary. Cleaning Disk X % Complete The hard disk is being cleaned. No action necessary. Clearing paper path The device jammed or the power was turned on and media was detected in the paper path. The device will automatically attempt to eject the media. No action necessary. Close left door Printing will resume when the door is closed. Close the left-side door. Close lower left door Printing will resume when the door is closed. Close the lower left-side door. Close lower right door Printing will resume when the door is closed. Close the lower right-side door. Close middle right door Printing will resume when the door is closed. Close the middle right-side door. Close upper right door Printing will resume when the door is closed. Close the upper right-side door. Code CRC Error An error occurred during a firmware upgrade. Resend the upgrade. Digital send communication error An error has occurred during a digital send task. Contact the network administrator. Verify that the DigitalSend software is operating and that the DigitalSend software and the MFP are connected to the network. Digital Send Server is not Responding Contact Administrator The MFP cannot communicate with the DigitalSend server Contact the network administrator. Verify that the DigitalSend software is operating and that the DigitalSend software and the MFP are connected to the network. Document feeder cover open The document feeder (ADF) cover is open. Close the document feeder (ADF) cover. Follow the instructions in the onscreen dialog box. 432 Chapter 6 Troubleshooting ENWW