HP PSC 2500 HP PSC 2500 series All-in-One - (English) Reference Guide - Page 177
enter WPA encryption data, LAN. To improve data encryption
View all HP PSC 2500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 177 highlights
wireless network setup wireless network setup to enter multiple WEP keys onto the embedded Web server 1 Enter either the URL or device IP address obtained from the network configuration page into the Address field on your browser. The EWS Home page appears, showing the hp psc 2500 series Device Info. 2 From the Home page navigation menu, click Select Language. 3 Use the drop-down box to select a language for the Web interface. 4 Click the Networking tab. The Network Settings page appears. The General tab is open. 5 Click the Wireless tab. 6 Scroll down to the Encryption section where you can add Static (WEP) encryption parameters 7 Select Enabled. 8 Under Static (WEP), enter the WEP keys used by your network 9 Select whether the keys entered are Alphanumeric or Hexidecimal. 10 Choose the key to be used to encrypt transmitted data. 11 Click Apply. Note: If you've forgotten your WEP key(s), try to view them through your access point. If your access point will not display them, reconfigure your network and assign new keys. enter WPA encryption data Wi-Fi Protected Access (WPA) provides standards-based, interoperable security to strongly increase the level of data protection and access control for a wireless LAN. To improve data encryption, WPA uses the Temporal Key Integrity Protocol (TKIP). To strengthen user authentication, WPA implements 802.1x and the Extensible Authentication Protocol (EAP). If WPA is in use on your network, you are either using 802.1x (server-based) or PSK (Pre-Shared Key) authentication. Enter the authentication and encryption information in the HP PSC embedded Web server prior to software installation. Note: You must have a wired connection to access the embedded Web server and configure your wireless settings prior to installation. For more information, see connect your hp psc to a wireless network or computer on page 147. to enter WPA encryption data onto the embedded Web server 1 Enter either the URL or device IP address obtained from the network configuration page into the Address field on your browser. The EWS Home page appears. 2 Click the Networking tab. 3 On the Network Settings page, select the Wireless tab. 4 Scroll to the Authentication section, and click Advanced Configuration. The Wireless Communication Mode page appears. reference guide 167