HP Portable 386 Compaq Portable 386 Personal Computer Maintenance and Service - Page 139
Turn off the 300/600 Megabyte Fixed Disk Drive Expansion Unit hereafter, Fixed Disk Drive
View all HP Portable 386 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 139 highlights
Preparation Procedures Before beginning the removal and replacement procedures, complete the following steps. 1. Turn off the computer. 2. Turn off the 300/600 Megabyte Fixed Disk Drive Expansion Unit (hereafter referred to as the fixed disk drive expansion unit). 3. Disconnect all power to the computer and the fixed disk drive expansion unit. 4. Disconnect the signal cable from the fixed disk drive expansion unit to the computer. 5. Place the fixed disk drive expansion unit on a flat surface with the back of the unit facing you. 6. Remove the retaining screws from the rear of the unit (Figure 8-106). 7. Facing the front of the fixed disk drive expansion unit, slide the cover forward until it stops. Then lift the cover up and away from the unit. Fixed Disk Drive To remove the fixed disk drive from the fixed disk drive expansion unit, complete the following steps. 1. Complete the preparation procedures at the beginning of Section 8-30.