HP Portable 386 Compaq Portable 386 Personal Computer Maintenance and Service - Page 155
Configuration Switch Bank SW3 is found on the COMPAQ Enhanced Color Graphics
View all HP Portable 386 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 155 highlights
COMPAQ Dual Mode 80 x 25 OFF ON OFF ON COMPAQ Monitor (720 x 350 Video resolution) Display Controller or Color Graphics Adapter 80 x 25 COMPAQ Dual Mode 80 x 25 ON ON OFF ON COMPAQ Monitor (720 x 350 Video resolution Display Controller or Color Graphics Adapter 40 x 25 Configuration Switch Bank SW2 The monitor type used with the COMPAQ Enhanced Color Graphics Board determines the settings for configuration switch bank SW2. Configuration switch bank SW2 is located at the top of the board, near the board slot bracket, as shown in Figure 9-2 or 9-3. Table 9-12 shows the correct settings for configuration switch bank SW2. Table 9-12. Configuration Switch Bank SW2 Settings SW2 Switches Monitor Type 1 2 3 4 5 6 COMPAQ Color Monitor or OFF OFF ON ON OFF ON Compatible Enhanced Color Monitor RGB Color Monitor ON OFF ON ON OFF ON Configuration Switch Bank SW3 Configuration Switch Bank SW3 is found on the COMPAQ Enhanced Color Graphics Board (Assy No. 000410 only). If it is installed, all switch settings are OFF. Jumper P1 The type of external monitor used with the COMPAQ Enhanced Color Graphics Board determines the setting for Jumper P1. The location of Jumper P1 is shown in both Figures 9-2 and 9-3. Jumper P1 is preconfigured for the COMPAQ Color Monitor or a compatible enhanced color monitor. Table 9-13 shows the correct settings for Jumper P1. If you need to reset the jumper, remove it from its current position and press it into place on the correct pins.