HP Vectra VE C/xxx 7 HP Vectra VE C/xxx Series 7 PC - Network Administration G - Page 59
NDIS 2.01 Driver for Artisoft LANtastic 6.0, Installation Procedure, system. If Windows is not found
![]() |
View all HP Vectra VE C/xxx 7 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
4 Installing Other Network Drivers NDIS 2.01 Driver for Artisoft LANtastic 6.0 NDIS 2.01 Driver for Artisoft LANtastic 6.0 Artisoft LANtastic 6.0 uses the NDIS 2.01 specification. To install the NDIS 2.01 driver in LANtastic versions earlier than 6.0, please contact your Artisoft representative. The NDIS 2.01 driver itself is provided in the NDIS\DOS directory. Installation Procedure To install a driver for LANtastic 6.0, start from the DOS system prompt. Follow the steps listed below: 1 Insert Disk 1 of LANtastic 6.0 into your flexible disk drive (for example, A). At the DOS prompt type: A:\install This starts the LANtastic installation process. 2 Artisoft's installation program will then search for Microsoft Windows on your system. If Windows is not found, press at the message to run the install program under DOS and go to the steps given under See "Installation for DOS" on page 60. Otherwise, if Windows is found, Windows will be started. Go to the steps given under See "Installation for Windows" on page 61. English 59
![](/manual_guide/products/hewlettpackard-vectra-ve-cxxx-7-hp-vectra-ve-cxxx-series-7-pc-network-administration-guide-4181996/59.png)