HP Xw4600 HP xw4600 Workstation - Service and Technical Reference Guide - Page 155
Run the Computer Setup F10 Utility and save - parity check 2
UPC - 883585516483
View all HP Xw4600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 155 highlights
Table 6-18 POST error messages (continued) Screen message Probable cause Recommended action 1802-Processor Not Supported The system board does not support the Replace the processor with a compatible one. processor. 1803-BIOS Update Needed for This BIOS revision does not support Install the latest BIOS downloaded from Processor the installed processor. http://www.hp.com. 1998-Master Boot Record has been lost The previously saved copy of the MBR Run the Computer Setup (F10) Utility and save the is corrupted. MBR of the current bootable disk. Invalid Electronic Serial Number Electronic serial number is corrupted 1. Run the Computer Setup (F10) Utility. 2. If the setup utility already has data in the field, or it will not allow the serial number to be entered, see http://www.hp.com. 3. Download and run the sp5572.exe (snzero.exe) utility. 4. Run the Computer Setup (F10) Utility again and try to enter the serial number under Security>System ID. 5. Ssave the changes. ECC Multiple Bit Error Detected in Memory Module The chipset has detected more than Replace the memory module. one bad bit in a 64-bit quadword of the memory array. Parity Check 2 Parity RAM failure. Run the Computer Setup (F10) Utility and the Diagnostic utilities. ENWW POST error messages 145