IBM 4400-006 User Manual - Page 103

TCP/IP Access Problem TCP/IP Access Problem If you can ping the printer from a workstation, but you cannot Web browse (Smart Ethernet Interface), Telnet, or print to the printer through the Ethernet Interface, there may be an incorrect entry in the TCP access list. For this workstation to use the Ethernet Interface in this case, one of two things must happen. • The TCP list must have an entry added to grant access to this workstation - OR - • All entries must be deleted from the TCP list to grant all workstations/hosts access to the above TCP services. To view the current access list, print an E-Net Test Page. When the page prints, look under the "TCP ACCESS TABLE" section for the TCP access list entries. To add/delete a TCP access list entry, refer to "TCP Access Lists" on page 287. NOTE: When the following procedure is used, the TCP access list will be cleared, but all IP addresses will need to be entered again after the procedure is complete. To reset all TCP/IP values to the factory defaults when access is impossible: 1. Obtain a printer configuration printout using the control panel. See the User's Manual for configuration menu information. 2. Power off the printer. 3. On the Ethernet Interface, place SWITCH 1 in the down position. 4. Power on the printer and wait for the ONLINE state. 5. On the Ethernet Interface, place SWITCH 1 in the up position. 103