IBM 4400-006 User Manual - Page 38
Gateway Ping Test, where, Your Ethernet Interface is now con d and connected to your
View all IBM 4400-006 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
Chapter 2 Configuration Tools The Netmask must be the same in both locations. For example, if the Netmask is listed as 255.255.255.0 in NETWORK INTERFACES and is listed as 255.255.255.255 in the TCP/IP ROUTING TABLE, they do not match and you must correct it for the Gateway. Also, if a Gateway Address was entered, verify that "xxx.xxx.xxx.xxx is alive" is printed under the Default Gateway Ping Test, where xxx.xxx.xxx.xxx is the Gateway Address. If a Gateway Address was not entered, the Default Gateway Ping test is not required and will not display on the page. If the Netmask does not match, complete the following steps: a. Place the printer offline. b. Using the front panel, modify the Gateway value to 0.0.0.0. (non-configured). c. Place the printer online and wait for the "E-NET READY" message to display. d. Place the printer offline and enter the Gateway Address you desire. e. Place the printer online and wait for the "E-NET READY" message. This saves the new Gateway Address. Your Ethernet Interface is now configured and connected to your network. 38