IBM 4400-006 User Manual - Page 36
CAUTION, 100Base-T Ethernet adapters. If the Ethernet Interface
View all IBM 4400-006 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Chapter 2 Configuration Tools CAUTION 5. Verify the current Ethernet Interface firmware version number. NOTE: Firmware exists within the Ethernet Interface and the printer itself. Each firmware is a separate entity with its own version number. Please pay close attention to the type of firmware referenced in the remaining sections of this document. The Ethernet Interface version should be 1.1.3 or higher for 10/100Base-T Ethernet adapters. If the Ethernet Interface version is current, skip to step 6 below. If the Ethernet Interface version is not current, you need to update both the Ethernet Interface and printer firmware. If you need to update the printer firmware, you must do so now. After the update is complete, you must restart this instruction from the beginning. To upgrade the printer firmware, contact your IBM service representative. Turning off the printer before the firmware update is complete may permanently damage the Ethernet Interface adapter. Updating the printer firmware takes time. Please be patient and wait for the "E-NET READY" message to display on the LCD. Do not turn off the printer before it has completed the firmware download procedure. The LCD will display "ONLINE / E-NET READY" when the download is complete. Wait for this message before turning off the printer. 6. From the front panel, navigate to the IP Address and Netmask (Subnet Mask) menu options and enter appropriate values. Do not enter the Gateway Address at this point. You must press ↵ after inputting each segment of the IP Address and Netmask. 36