IBM 4400-006 User Manual - Page 35

Configuration Using The Control Panel Configuration Using The Control Panel SMART CAUTION You can set Ethernet Interface settings from the printer control panel. When the printer is first powered on, the message "E-NET INIT" displays on the control panel. This process takes about two minutes. To prevent a loss of Ethernet Interface configuration information, do not change the Ethernet Interface settings while this message is displayed. When the initialization is complete, the message "E-NET READY" displays, and you can safely change the Ethernet Interface settings from the control panel. 1. You can set any of three listed parameters from the printer control panel. These parameters are located in the Arrange to have an IBM service technician install the Ethernet Interface card if it is not already installed; this is not a customer installable feature. 2. Power on the printer. The message "E-NET INIT" appears when the printer is powered on. Configuration can be done after the "E-NET READY" message appears (about 1 to 2 minutes after the "E-NET INIT" message displays). 3. Disable the Power Saver mode before starting this procedure, see the 4400 Setup Guide for instructions. 4. Always print an E-NET test page before performing any updates or network configuration using the following steps: For 4400 printers: a. Take the printer offline. When the printer LCD reads, "OFFLINE," press the ↓ and ↵ keys simultaneously to unlock the control panel. b. Press the + key until "PRINTER TESTS" appears. Continue pressing the + key until "PRINTER TESTS/E-NET TEST PAGE" appears. Press ↵. 35