IBM 4400-006 User Manual - Page 262

Chapter 15 Complete Command List • off. no job control; no SOJ/EOJ commands. The printer prints faster in off mode. • standard. (the default) traditional job control with immediate acknowledgements of SOJ/EOJ commands. • enhanced. job control with EOJ acknowledgements held off by the printer until job is fully printed. The printer prints slower in enhanced mode. To monitor the printer, use the telnet command "lpstat." The normal status reported on the first line of the lpstat response is the status of the queue (LPQ) within the Ethernet. The status reported does not reflect the state of the print job once it has been sent from the Ethernet to the printer. The new line at the bottom of the lpstate response labeled "printer job:" can report one of two status values: a. In Progress. A job in the printer is not yet finished. b. Done. There are no jobs in the printer. All previous jobs are finished. store pserver lpd [-]dest1default example: store pserver lpd dest1default If dest1default is disabled and upon verification, the printer name supplied by the LPR protocol and the destination name does not match, then an error message is returned and the service is refused. If dest1default is enabled and upon verification, the printer name supplied by the LPR protocol and the destination name does not match, then the job is automatically routed to the first destination and the service is accepted. Default: enabled store pserver tcpsocket TCPportnumber port newTCPportnumber example: store pserver tcpsocket 4000 port 5000 Change a pre-defined TCPportnumber on the Ethernet Interface to a newTCPportnumber. The default number is 9100 for prn. 262