IBM 4400-006 User Manual - Page 138

Chapter 6 Novell Host Configuration 14. Select this new printer and press ENTER. Go to the Type field. 15. Press ENTER at this field and select DEFINED ELSEWHERE. If DEFINED ELSEWHERE is not available, choose PARALLEL. 16. Press ENTER on the Print Queues Assigned field. 17. Press INSERT to display all queues; select the one you defined in step 5 and press ENTER. 18. Select a priority and press ENTER. Priority 1 should be sufficient. 19. Press ESCAPE, saving your changes, until you are back to Main Menu. 20. Reboot the Print Server by repowering the printer. 21. Check the CURRENTLY ATTACHED SERVERS and verify the print server is active. 22. Press ESCAPE until you are out of the PCONSOLE. Even though the entire print set up is done through PCONSOLE, you may want to communicate directly with the print server to modify settings, monitor the unit, etc. To communicate with the print server, the optional host software, npsh.exe, is included. npsh.exe is a DOS executable program that can be run from a DOS prompt on a NetWare workstation. npsh.exe performs the following: npsh nvplist Lists all of the Ethernet Interface devices on the network; each name is in the default format M_xxxxxx (where xxxxxx equals the last six digits of the unit Ethernet address). This is regardless of whether it is configured as a PSERVER or as an RPRINTER. npsh unitname Starts a Telnet-like session with the named print server, allowing you to configure, monitor, and troubleshoot the unit with the built-in command set. npsh unitname command Initiates a single command with guest access only to the unit instead of entering into a complete session. 138