IBM 4400-006 User Manual - Page 27

DIP Switches SMART NOTE: When running LMU1 emulation the test page will not print if the ASCII Text Mode menu setting is set to Absorb. To print the test page, under LMU1 emulation, change the ASCII Text Mode parameter from Absorb to Auto Passthru. Table 4. 10/100Base-T DIP Switch Settings (Smart Ethernet) DIP Switch 1 2 Comments up down up down up up down down Normal operation. With both DIP switches in the "off" position, the Ethernet Interface boots up using the settings in flash memory rather than the default settings. Factory default. With the DIP switches in this configuration, the Ethernet Interface boots up and all settings stored in flash memory are erased except the Ethernet address and key value. Default IP. With the Smart Ethernet and DIP switches in this configuration, the Ethernet Interface boots up with factory default settings. However, the stored settings in flash memory are intact. Setting DIP switch 2 to "on" does not clear any settings stored in flash memory; it boots the unit in a different state with the settings in flash memory temporarily ignored. Reserved. This DIP switch configuration is not for customer use. Please refer to the Setup Guide for details. 27