IBM 4400-006 User Manual - Page 116

Chapter 5 Unix Host Configuration 2. At the "Network Configuration" HTML form that displays, click in the first field below the "Gateway" heading and type in the IP address of the default router/gateway for the Ethernet Interface subnet. 3. Click the SUBMIT button when done and physically repower the print server to make sure the new setting is in effect. Configuring A Default Router/Gateway To configure a default router/gateway using the Ethernet Interface internal command shell, npsh: 1. Telnet to the Ethernet Interface, and log in as root with no password. 2. At the system prompt, enter the command to store the default router/gateway address: store tcpip route add default routerIPaddress 1 (e.g., store tcpip route add default 192.75.12.0 1) 3. Repower the printer to have the stored setting to take effect. Unix Host Configuration There may be times when you would prefer or have to perform the manual setup steps for a new printer definition. There may also be times when you require a less common print solution such as direct socket capabilities. This section covers these additional setups. Manual System V Host Setup This print setup involves spooling (e.g., SanCyOU, nSioxloapries®ra,tHinPg-sUyXs®te,mDGus/UinXg®S,yesttce.m). TVhis means an interface file is used for each defined printer and, in the case of any System V print setup involving an Ethernet Interface, the RSHD protocol is used to transfer data from the host to the print server. 116