IBM 4400-006 User Manual - Page 281

Miscellaneous Commands Miscellaneous Commands These commands do not fall under any specific section of the command shell, but they are used quite frequently. save [default] Save the current settings to flash memory so they are available after power cycles. Sysinfo, destination, model, logpath, variable, user, and I/O port settings will be saved. If default is specified as well, factory settings will be saved, overwriting any new settings you have configured. reset Perform a warm boot or hardware reset to simulate a power-on reset. This restores current settings to those stored in flash memory, since the flash memory settings will be read and loaded into memory upon bootup. load [default] Load the settings stored in flash memory and use them as the current or working settings. If default is specified as well, factory settings will be loaded. lpstat [ioport] [jobID] example: lpstat prn Display active and queued jobs and I/O port status for a given ioport or jobID. Specifying one of these parameters will shorten the output and focus on the particular I/O port or print job specified. cancel jobID example: cancel d1prn-10 Remove a job from an I/O port queue. Use lpstat to find a particular job ID first. 281