IBM 4400-006 User Manual - Page 278

Chapter 15 Complete Command List IMPORTANT Do not delete the root user, or you will be unable to configure any further settings on the print server. You will have to go back to factory defaults to correct this problem. set user passwd username password example: set user passwd eng mplex1 Assign a password to a defined user on the Ethernet Interface. This password must be less than eleven characters. set user type username root|guest example: set user type eng root Assign root or guest privileges to a particular user defined by username. Guest permissions allow viewing of settings only. Root permissions allow complete control of the Ethernet Interface. set user from default Set all user settings back to factory defaults. set user from stored Set all current user settings to the values stored in flash memory. set user passwd snmp com_name Set the new SNMP R/W community name as the com_name value. set var variablename variablestring example: set var LANDSCAPE 0x1b 0x26 0x6c 0x31 0x4f Define a new variable to be used in header, trailer, or switch strings on the Ethernet Interface and call it variablename. The variablestring can be a space-separated list of words, hexadecimal numbers (e.g., 0x04), or references to other predefined variables. It is easiest to make up the variablestring with hexadecimal values, as shown in the example. NOTE: One variable counts as one element within header and trailer strings. NOTE: Defined variables are referenced in strings by placing a "$" before the variable name (e.g., set model m1 trailer $FF). 278